Suzuki WagonR+ RB310 Service Manual page 2228

Vehicle
center
side
Upper side
LARGE
1
14) While supporting rear axle at both ends (right & left), remove
trailing arm rear side bolts and then remove rear axle from
chassis by lowering floor jack gradually.
INSTALLATION
Install removed parts in reverse order of removal, noting the follow-
ing points.
1) Place rear axle on floor jack. Then install lateral rod to rear axle
and tighten nut temporarily by hand.
2) Install trailing arm rear bolts (1) (right & left) in proper direction
as shown in figure. Then tighten nuts (2) temporarily by hand.
Vehicle
outside
3) Install coil springs (1) (right & left) on spring seat (2) of rear axle
as shown in figure and then raise rear axle.
SMALL
NOTE:
When seating coil spring (1), mate spring end with stepped
part (3) of rear axle spring seat as shown.
4) Tighten shock absorber lower bolts (1) (right & left) temporarily
by hand.
5) Remove floor jack from rear axle.
REAR SUSPENSION 3E-15