Suzuki WagonR+ RB310 Service Manual page 3032

TABLE A – AIR BAG WARNING LAMP COMES ON STEADY WITHOUT FLASHING
TABLE B – AIR BAG WARNING LAMP DOES NOT COME ON WITH IGNITION SWITCH ON
TABLE C – AIR BAG WARNING LAMP FLASHES EVEN AFTER INITIAL 6-TIME FLASHING
TABLE D – AIR BAG WARNING LAMP CANNOT INDICATE FLASHING PATTERN OF DTC
TABLE E – SCAN TOOL CANNOT COMMUNICATE SDM
- 1. From main fuse
- 2. Ignition switch
- 3. "AIR BAG" warning lamp in combination meter
4-1. "AIR BAG" fuse in circuit fuse box
4-2. "IG COIL" fuse in circuit fuse box
CAUTION:
D Be sure to perform "Air Bag Diagnostic System Check Flow Table" in this section before starting diag-
nosis according to flow table.
D When measurement of resistance or voltage is required in this table, use a special digital multimeter
(refer to SPECIAL TOOLS in this section) along with a correct terminal adapter from special tool (Con-
nector test adaptor kit).
D When a check for proper connection is required, refer to "Intermittent and Poor Connections" in this
section.
D If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
- 5. SDM case ground
- 6. SDM
- 7. DLC (Data Link Connector)
- 8. To ECM, ICM (if equipped), EPS control
module (if equipped) and ABS controller (if equipped)
AIR BAG SYSTEM 10B-15
: Shorting bar
:Air bag harness
- 9. Air bag monitor coupler
-10. Ground for air bag system
-11. From circuit fuse