Fuel Filler Cap - Suzuki WagonR+ RB310 Service Manual

6C-6 ENGINE FUEL
1. Clamp location mark
1. Clamp
2. Pipe cover
6) Mark the location of clamps on fuel pipes, so that the clamps can
be reinstalled to where they were.
7) Remove pipes (3) with clamp (2) from vehicle.
8) Remove clamp from pipes.
INSTALLATION
1) Install clamps to marked location on pipes. If clamp is deformed
or its claw is bent or broken, replace it with a new one.
2) Install pipes with pipe clamps to vehicle.
3) Connect fuel hoses and pipes to each pipe.
CAUTION:
When connecting joint, clean outside surfaces of pipe
where joint is to be inserted, push joint into pipe till joint
lock clicks and check to ensure that pipes are connected
securely, or fuel leak may occur.
4) Install pipe cover (2) to vehicle.
5) Install steering gear box. Refer to Section 3B for details.
6) With engine "OFF" and ignition switch "ON", check for fuel leaks.

FUEL FILLER CAP

Remove cap (1), and check gasket (2) for even filler neck imprint,
and deterioration or any damage. If gasket is in malcondition, re-
place cap.
NOTE:
If cap requires replacement, only a cap with the same features
should be used. Failure to use correct cap can result in critical
malfunction of system.