Preparing The Control Unit; Connecting A Geared Motor To The Control Unit - Siemens SIDOOR AT40 System Manual
Automatic door control units
Hide thumbs
Also See for SIDOOR AT40:
- System manual (337 pages) ,
- Operating instructions manual (6 pages) ,
- Operating instructions (4 pages)
Table of Contents
Advertisement
Connecting and commissioning
9.3 Connecting a geared motor to the control unit
9.2
Preparing the control unit
Preparing the control unit for connection and installation
1. Nudge the door into the CLOSED position.
2. Open the housing cover.
9.3
Connecting a geared motor to the control unit
Connecting a geared motor to the control unit
Connect the motor plug(s) as follows:
• SIDOOR AT40, ATD400V: Slot X7 on the controller
Note
SIDOOR AT40, ATD400V
The X6 control inputs plug is not plugged in during commissioning in order to prevent
uncontrolled movements.
160
X7
AT40 and ATD400V for elevators
System Manual, 06/2022, A5E42192709-AH
Advertisement
Table of Contents
