(3)
Remove 1 screw and take off the sensor
cover.
(4)
Disconnect 1 connector and take off the
original tray width sensor.
4.12.47 Original exit/reverse sensor (SR11)
(1)
Take off the platen sheet unit.
(
P.4-120 "4.12.8 Platen sheet unit")
(2)
Remove 1 screw and take off the locking
lever on the front side. Remove 1 screw and
take off the locking lever on the rear side.
Remove 1 spring and take off the locking
bracket.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
Spring
Locking lever
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 156
Fig. 4-444
Fig. 4-445
Locking lever
Locking Bracket
Fig. 4-446