Drum Surface Potential Sensor (S13) - Toshiba e-STUDIO556 Service Manual

4.6.4

Drum surface potential sensor (S13)

(1) Take off the cleaner unit.
( P.4-61 "4.7.1 Cleaner unit")
(2) Disconnect 1 connector, remove 1 screw,
and then take off the sensor bracket.
(3) Disconnect 1 connector, remove 1 screw,
and then take off the surface potential sensor
(detection section).
(4) Disconnect 1 connector, release 4 lock
supports, and then take off the surface
potential sensor (board section).
Note:
The drum surface potential sensor consists
of the detection section and the board
section as a set.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
Sensor bracket
Connector
Drum surface potential sensor ( board section )
Drum surface potential sensor
( detection section )
Locking support
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 58
Screw
Fig. 4-164
Screw
Fig. 4-165
Locking support
Fig. 4-166