Toshiba e-STUDIO556 Service Manual page 591

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

Table of Contents

[ 5 ] Other paper jam

[EAD0] Print end command time-out jam

Is the main motor rotating normally?

1. Check if there is any paper in the equipment. Remove it if there is.

2. If the error still occurs, check the following:

3. Check if the error is cleared by turning the power OFF and then back ON.

4. Check if the connectors connecting the SYS board, SLG board and PLG board are

disconnected.

5. Check if the harnesses connecting the SYS board, SLG board and PLG board are open

6. Replace the SYS board and LGC board.

[EAE0] Receiving period time-out jam

Is the finisher working?

1. Check if the voltage (24V) is being supplied to the finisher.

2. Check the connection of the LGC board and IPC board.

3. Check if the harness connecting the IPC board and finisher I/F connector of the

equipment side is open circuited.

4. Check if the harness connecting the I/F connector of the finisher side and finisher

controller PC board is open circuited.

5. Replace the finisher controller PC board.

Replace the finisher controller PC board.

e-STUDIO556/656/756/856(Ver03)

ERROR CODE AND TROUBLESHOOTING

Chapters

Table of Contents