Toshiba e-STUDIO556 Service Manual page 170

[C] Winding the wires around the wire pulley
(1) Pull the O3 ball terminal located at the center
of the wire into a hole on the wire pulley. One
end of the wire with a hook attached comes
to the outside.
(2) Wind the wires around the wire pulleys of the
front and rear sides. The number of turns to
be wound are as follows:
2 turns toward the opposite side of the boss
4 turns toward the boss side
Notes:
Pay attention to the followings when the
wires are wound around the pulleys:
• Do not twist the wire.
• Wind the wires tightly so that they are in
complete contact with the surface of the
pulleys.
• Each turn should be pushed against the
previously wound turn so that there is no
space between them.
(3) After winding the wires around the pulleys,
attach the wire holder jigs not to loosen the
wires.
Notes:
• When the wire holder jig is attached,
make sure that the wire is not shifted or
loosened.
• The wire should come out of the slot of
the wire holder jig and be passed under
the arm of it.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
[ Rear ] 2 turns
Ball terminal
Hook
[ Front ]
No space between turns
Color: Black
Wire holder jig
Wire holder jig
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 24
4 turns
No space between turns
Color: Silver
Fig. 4-65
4 turns 2 turns
Ball terminal
Hook
Fig. 4-66
Arm
Fig. 4-67