Separation Roller - Toshiba e-STUDIO556 Service Manual

4.12.15 Separation roller

(1) Take off the RADF front cover.
( P.4-116 "4.12.2 RADF front cover")
(2) Take off the RADF rear cover.
( P.4-117 "4.12.3 RADF rear cover")
(3) Remove 4 screws and take off the feeder
upper guide unit.
(4) Remove 1 screw and take off the separation
roller holder [1]. Then take off the separation
roller unit.
Note:
Do not peel off the film [2] of the separation
roller holder since it is fixed to the RADF with
double-faced adhesive tape.
(5) Remove 1 E-ring and 1 bushing and then
take off the separation roller.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
[1]
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 128
Fig. 4-362
[2]
Fig. 4-363
Fig. 4-364