Transport Sleeve - Toshiba e-STUDIO556 Service Manual

(11) Remove 2 seals, 4 shield bushings, the
scraper, and then take off the upper and
lower developer sleeves.
(12) Replace the oil seal pressed into 2 shield
bushings on the rear side, if necessary.
* Procedure for replacing an oil seal:
( P.4-82 "4.8.18 Procedure for
replacing an oil seal")
4.8.15

Transport sleeve

(1) Remove 1 screw and then the pole position
fixing bushing on the rear side.
(2) Remove the gear, E-ring and bearing on the
front side, and then take off the transport
sleeve.
(3) Replace 1 oil seal pressed into the front side
of the frame, if necessary.
* Procedure for replacing an oil seal:
( P.4-82 "4.8.18 Procedure for
replacing an oil seal")
© 2012 TOSHIBA TEC CORPORATION All rights reserved
Oil seal
Shield bushing
Fig. 4-224
Screw
Fig. 4-225
Bearing E-ring
Transport sleeve
Fig. 4-226
4 - 79
Shield bushing
Scraper
Pole position fixing bushing
Gear
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4