New Toner Supply Motor (M5) - Toshiba e-STUDIO556 Service Manual

4.8.3

New toner supply motor (M5)

(1) Remove 3 screws to take off the top cover.
(2) Disconnect 1 connector, remove 2 screws,
and then take off the new toner supply motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
4.8.4 Toner cartridge empty sensor (S10)
(1) Remove 2 screws, and then take off the
toner cartridge empty sensor with the
harness.
(2) Disconnect 1 connector from the toner
cartridge empty sensor.
Note:
Be careful not to damage the sensor when
connecting and disconnecting the connector.
4.8.5 New toner transport motor (M6)
(1) Remove 3 screws to take off the top cover.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
New toner supply motor
Toner cartridge empty sensor
Top cover
Screw
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 70
Screw
Connector
Fig. 4-197
Fig. 4-198
Screw
Fig. 4-199