Toshiba e-STUDIO556 Service Manual page 236

(6) Lift up the transfer/transport unit to release
the hook.
(7) Push in the slide rail while loosening the slide
rail on the right side.
(8) Shift A or B from your left to your right hand
and then hold C in your left hand.
(9) Take off the transfer/transport unit from the
slide rail by lifting it up.
Notes:
1. When lifting up the transfer/transport unit,
do not hold D (Transport guide) because
it may cause damage to the transport
guide.
2. When installing, follow the procedure
below.
(10) Pull out the slide rail on the left side
completely.
(11) Hook the transfer/transport unit on the slide
rail on the left side properly.
(12) Extend the slide rail on the right side. Make
sure to extend the leading edge of the slide
rail completely.
(13) Hook the transfer/transport unit on the slide
rail on the right side.
(14) Fix the transfer/transport unit with 2 stepped
screws.
(15) Assemble it in the reverse order of the
disassembling procedure.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
Catch-up
section
C
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 90
Fig. 4-255
D
Fig. 4-256