Toshiba e-STUDIO556 Service Manual page 184

(3) Remove 2 E-rings to pull out the transport
rollers from the shaft.
[ 4 ] Intermediate transport sensor (S17)
(1) Disconnect 1 connector.
(2) Take off the sensor while the sensor arm is
pushed downward (the shield plate is pushed
upward).
Note:
When installing the sensor, make sure the
sensor arm moves properly.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
Transport roller
Sensor arm
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 38
Fig. 4-107
Intermediate transport sensor
Fig. 4-108