Toshiba e-STUDIO556 Service Manual page 777

[I] Backup license
Note:
If "3. License SRAM to FROM" is performed by mistake, carry out the following procedure.
P.9-30 "[A] Re-registration when the board is replaced"
(1) Turn the power ON while pressing [3] and the [C] button simultaneously.
(2) Enter the password, and then press the [OK].
(If the password is not set for Service, press the [OK] button without entering anything.)
(3) Key in [5] to select "5. Key Backup Restore", and then press the [START] button.
(4) Key in [4] to select "4. License FROM to SRAM", and then press the [START] button.
(5) Wait until the backup of the license is completed. "Operation Complete" is displayed.
(6) Restart the equipment after the backup is completed.
(7) Turn the power OFF.
[J] Initialize SRAM board
(1) Turn the power ON while pressing [0] and [8] simultaneously.
(2) Enter the password, and then press the [OK].
(If the password is not set for Service, press the [OK] without entering anything.)
(3) Initialize the SRAM error.
1. When "SRAM REQUIRES INITIALIZATION" is displayed on the LCD, check the destination
and then press the [START] button.
If the destination is not correct, key in the correct one and then press the [START] button.
2. After the confirmation message is displayed, press the [INTERRUPT] button.
(4) Perform the panel calibration (08-9050).
1.Touch the center of "+" mark displayed on the upper left of the LCD.
2.Touch the center of "+" mark displayed on the upper right of the LCD.
3.Touch the center of "+" mark displayed on the lower left of the LCD.
4.Touch the center of "+" mark displayed on the lower right of the LCD.
(5) Perform the initialization at the software version upgrade (08-9030).
(6) Initialize the NIC information (08-9083).
(7) Enter the serial number (08-9601).
Key in the serial number on the label attached to the rear cover of the equipment, and then press
the [OK].
(8) Turn the power off.
[K] Reinstall license
If the license was returned in "
(1) Turn the power ON while pressing [0] and [8] simultaneously.
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3) Key in [3840], and then press the [START] button.
(4) Press the [INSTALL] button.
(5) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK] button.
(6) Select the license to be installed, and then press the [INSTALL] button.
(7) The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(8) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
© 2012 TOSHIBA TEC CORPORATION All rights reserved
P.9-21 "[B] Return License", reinstall it with the following procedure.
9 - 23
e-STUDIO556/656/756/856(Ver03)
REPLACEMENT OF PC BOARDS / HDD
9