Toshiba e-STUDIO556 Service Manual page 588

[ 4 ] Paper jam in inserter section
[EC00] Inserter feeding delay jam
Are the pickup roller, feed roller and separation roller tainted?
YES
NO
Is the harness between the inserter control board and separation sensor open-circuited?
YES
NO
Is the separation sensor working improperly?
YES
NO
Replace the inserter control board.
[EC10] Inserter feeding stop jam
Are the transport roller and reverse roller tainted?
YES
NO
Is the harness between the inserter control board and separation sensor open-circuited?
YES
NO
Is the separation sensor working improperly?
YES
NO
Replace the inserter control board.
e-STUDIO556/656/756/856(Ver03)
ERROR CODE AND TROUBLESHOOTING
Clean up the rollers.
Replace the harness.
Replace the separation sensor.
Clean up the rollers.
Replace the harness.
Replace the separation sensor.
8 - 80
© 2012 TOSHIBA TEC CORPORATION All rights reserved