Finisher Jam - Toshiba e-STUDIO556 Service Manual

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

Table of Contents

Finisher jam

[ 1 ] Paper jam in puncher unit

[E9F0] Hole punch jam

Is there any paper remaining on the transport path in the finisher or equipment?

Is the connector J1 on the punch driver PC board disconnected?

Is the harness connecting the punch driver PC board and punch home position sensor

(PI3P) open circuited?

Is the punch home position sensor working properly?

Replace the punch driver PC board.

[ 2 ] Paper jam in finisher section

[EA10] Paper transport delay jam

Is there any paper remaining on the transport path in the finisher or equipment?

Is the connector J17 on the finisher controller PC board disconnected?

Is the harness connecting the finisher controller PC board and inlet sensor (PI1) open

Is the inlet sensor working normally? (Check the movement of the actuator.)

Replace the finisher controller PC board.

e-STUDIO556/656/756/856(Ver03)

ERROR CODE AND TROUBLESHOOTING

Remove the paper.

Connect the connector securely. Replace the harness.

1. Connect the connector of the punch home position sensor securely.

2. Replace the punch home position sensor.

Remove the paper.

Connect the connector securely. Replace the harness.

1. Connect the connector of the inlet sensor securely.

2. Attach the actuator securely if its shaft is out of place.

3. Replace the inlet sensor.

Table of Contents