Toshiba e-STUDIO556 Service Manual page 160

Notes:
Be sure to install the lamp harness by
following the procedure below.
1. Using alcohol, clean the area where the
seal is to be attached.
2. Align the black line on the lamp harness
with the position as shown in the figure,
and fix it with a seal.
3. Align the bent portion of the lamp harness
with the position as shown in the figure,
and fix it with a seal.
4. After the installation, move carriage-1
towards the left and confirm that there is
no abnormality in the lamp harness, such
as twisting.
(7) Rotate the carriage-1 in the direction shown
in the figure at right, not to touch the mirror.
Then take off the carriage-1.
Note:
When replacing the mirror-1, replace the
carriage-1 together with mirror-1. Mirror-1
should not be removed.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
Lamp harness
Black Line
Hole
Punched mark
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 14
Lamp harness
Seal
Fig. 4-37
Lamp harness
Seal
Punched mark
Fig. 4-38
Fig. 4-39