Toshiba e-STUDIO556 Service Manual page 492

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

Table of Contents

Pickup roller / feed roller / separation roller

When installing the pickup roller and feed roller, pay attention to allocate the pickup roller,

gear, feed roller and one-way clutch correctly.

When replacing the separation roller, replace only the roller and continue to use the torque

Drive gears in the paper feeding section (teeth face and shafts)

Apply some white grease (Molykote EM-30) to the teeth faces and shafts of the drive

Make sure that oil is not running over or scattered around as the gear is rotated coming into the

clutch after applying molykote to the gear which is located near the clutch. The quantity of

molykote should be smaller than that to be applied to the other parts.

Main charger case / main charger wire

Clean the main charger case and wire with a cloth soaked in water and squeezed tightly,

and then wipe them with a dry cloth.

Be careful of the following when attaching a new wire (length: 363mm).

Insert the wire securely into the V-grooves of the front and rear sides.

Do not twist the wire.

Do not touch the wire with your bare hand.

e-STUDIO556/656/756/856(Ver03)

PREVENTIVE MAINTENANCE (PM)

Separation roller

Pickup roller

Chapters

Table of Contents