Toshiba e-STUDIO556 Service Manual page 545

Replace parts
egistration sensor
R
Registration motor
LGC board
* If the error [E010] caused by a paper jam underneath the drum cleaner often occurs due to an
insufficient paper separation from the photoconductive drum, set a smaller value in the code 08-
2960, and see what happens. At this time, however, pay attention to the transferability at the leading
edge of the paper since this transferability can be slightly narrowed depending on the environments
and conditions under which the equipment is placed or the media type of the paper used.
[E020] Paper stopping at fuser transport sensor
Classification
Paper exit jam
Check item
Fuser transport sensor
LGC board
Fuser
Drive unit, Rollers
Reverse motor
Replace parts
Fuser transport sensor
Reverse motor
LGC board
[E030] Power-ON jam
Classification
Other paper jam
Check item
Cover, Transport pass
© 2012 TOSHIBA TEC CORPORATION All rights reserved
The trailing edge of paper does not pass the fuser transport sensor after its
leading edge has reached the fuser transport sensor.
• Sensor check (Perform the input check: 03-[FAX]OFF/[7]/[C])
• Connector check
• Harness check.
• Connector check (CN332, CN335)
• Board check.
• Connector check
• Harness check.
• Gear check
• Roller check
• Motor check (Perform the output check:03-126)
• Harness check.
Paper is remaining on the paper transport path of the equipment when the
power is turned ON
• Open the cover of the unit/area whose picture is flashing on the control
panel and remove if there is any paper on the transport path. (Refer to
the table below.)
8 - 37
Remarks
Error item
Measures
Remarks
Error item
Measures
e-STUDIO556/656/756/856(Ver03)
ERROR CODE AND TROUBLESHOOTING
8