Toshiba e-STUDIO556 Service Manual page 188

(2) Remove 1 clip and take off the separation
roller by lifting the shaft.
[ 5 ] Bypass paper size detection sensor (S28)
(1) Disconnect 1 connector and release it from
the clamp.
(2) Remove 2 brackets on both sides of the tray
and 2 screws each to take off the bypass
tray.
(3) Remove 3 screws and release 4 latches to
take off the bypass tray upper cover.
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
Separation roller
Screw
Fixing bracket
Bypass tray upper cover
Latch
Screw
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 42
Clip
Fig. 4-118
Connector
Screw
Fig. 4-119
Hook
Latch
Fig. 4-120