Toner Recycle Unit - Toshiba e-STUDIO556 Service Manual

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

Table of Contents

Remove 2 E-rings and then 2 gears.

Remove 2 screws to take off the new toner

transport motor.

Pay attention to the size (length) of the

screws. If incorrect ones are used, the motor

could be damaged.

Toner recycle unit

Take off the toner cartridge drive unit.

P.4-69 "4.8.1 Toner cartridge drive unit")

Remove 2 screws to take off the left inner

Disconnect 1 connector, remove 2 screws,

and then take off the toner recycle unit.

1. Be extremely careful when handling this

unit because toner may spill out from the

joint with the toner recycle unit, cleaner

unit and developer unit.

2. Install the window of the shutter section

on the toner recycle unit so that it

matches with the protrusion of the

developer unit.

3. Be careful to allow as little vibration as

possible to the unit when installing and

removing the toner recycle unit. Vibration

could cause stains on the image after

assembling, especially when the

remaining toner amount in the cartridge is

e-STUDIO556/656/756/856(Ver03)

DISASSEMBLY AND REPLACEMENT

New toner transport motor

Toner recycle unit

Table of Contents