Recycle Toner Transport Motor (M8) And Hopper Motor (M7) - Toshiba e-STUDIO556 Service Manual

4.8.7

Recycle toner transport motor (M8) and Hopper motor (M7)

(1) Disconnect 1 connector, remove 2 screws,
and then take off the recycle toner transport
motor.
(2) Disconnect 1 connector, remove 2 screws,
and then take off the hopper motor.
Note:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
4.8.8 Developer unit
(1) Take off the toner recycle unit.
( P.4-72 "4.8.6 Toner recycle unit")
(2) Rotate the L-shaped shaft upward to release
the lock.
(3) Disconnect 1 connector and pull out the
developer unit to the front side.
4.8.9 Developer material
(1) Take off the developer unit.
( P.4-73 "4.8.8 Developer unit")
(2) Remove 2 screws to take off the top cover.
© 2012 TOSHIBA TEC CORPORATION All rights reserved
Hopper motor
Screw
Recycle toner transport motor
Fig. 4-206
Developer unit
Fig. 4-207
Top cover
Fig. 4-208
4 - 73
Connector
Screw
L-shaped shaft
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4