Default Value - Toshiba e-STUDIO556 Service Manual

[ 4 ] Operation
Connect the digital testers as described in "[3] Connection", and follow the procedure on the next
page to measure the output from the main charger and developer bias charger.
<Keys to press>
[0][5]
[POWER]
1
[Digital keys] : Enter the code.
[START]
Check that the measured value satisfies the following table.
[CANCEL]
Return to 1 to enter the
other adjustment code.
[POWER] : OFF
Disconnect the digital testers and return the equipment to its original state.
[0][5]
[POWER]
[Digital keys] : 2120
[START]
[POWER] : After the message "WAIT" has disappeared, turn the power OFF and then back ON.
Note:
If the output value does not reach a specified level, replace the high-voltage transformer.
e-STUDIO556/656/756/856(Ver03)
ADJUSTMENT
<Display>
100%
TEST MODE
100%
TEST MODE
YYY
Current set value
Code

Default value

Output value
100%
TEST MODE
Fig. 6-27
6 - 44
A
XXXX
Developer bias Main charger
2020 2040
113 (bit) 102 (bit)
-394±22V -500±22V
A
© 2012 TOSHIBA TEC CORPORATION All rights reserved
A3
A3
Code No.
A3