Toshiba e-STUDIO556 Service Manual page 440

[B] Duplex copying:
(1) Check the image using the chart (original)
with vertical and horizontal lines in the
following procedure.
Place the chart provided as an original with
its face up on the original tray of the RADF,
select [2 Sided -> 2 Sided] and make copies.
(2) Superimpose the chart on the copy and
check the leading edge E of the chart and F
of the copy.
(3) If the adjustment is necessary, shut down the
equipment and turn the power ON while
pressing [0] and [5] simultaneously, key in
[3045] and then press the [START] button.
(4) Enter the value.
If the leading edge (F) margin of the copy
image is larger than the (E) margin of the
chart, enter a value smaller than the current
one. If the leading edge (F) margin of the
copy image is smaller than the (E) margin of
the chart, enter a value larger than the
current one.
Note:
Changing one value shifts the copy image by
0.2 mm.
(5) Press the [OK] button.
e-STUDIO556/656/756/856(Ver03)
ADJUSTMENT
E
Chart (Original)
© 2012 TOSHIBA TEC CORPORATION All rights reserved
6 - 76
Chart
Fig. 6-85
F
Copy
Fig. 6-86