5.5
Test print mode (test mode 04)
The embedded test pattern can be printed out by keying in the following codes in the test print mode
(04).
<Operation procedure>
[0][4]
(Code)
[POWER]
Notes:
•
When an error occurs, it is indicated on the panel, but the recovery operation is not
performed. Turn OFF the power and then back ON to clear the error.
•
During test printing, the [C] button is disabled when "Wait adding toner" is displayed.
* Refer to "Appendix" in this manual for the codes available in the test print mode.
© 2012 TOSHIBA TEC CORPORATION All rights reserved
[START]
Operation
Continuous
Test Printing
5 - 9
[CLEAR]
[POWER] OFF/ON
(Exit)
e-STUDIO556/656/756/856(Ver03)
SELF-DIAGNOSTIC MODE
5