Safety Information On Getting Started; Switching On Babylog Vn500 And Infinity C500; Prerequisites To Getting Started - Dräger Babylog VN500 Instructions For Use Manual

Getting Started

Safety information on getting started

WARNING
Ventilation does not take place in standby
mode! The device must only be set to standby
mode when no patient is connected to the de-
vice. Other settings may jeopardize the pa-
tient!
CAUTION
Before using for the first time, the device must re-
main connected to the mains power supply for at
least 4 hours so that the internal battery can be
fully charged.
CAUTION
Before using the power supply unit PS500 for the
first time, the device must remain connected to
the mains power supply for at least 8 hours so that
the internal batteries can be fully charged.

Switching on Babylog VN500 and Infinity C500

Press the (A) button on Infinity C500.
A
The system is started. The Start dialog is dis-
played.
58
CAUTION
Condensation may form when the device is
moved from a cold storage location to a warm en-
vironment. Do not switch on the device as other-
wise its proper functioning may be adversely af-
fected. Wait until the condensation has dried.

Prerequisites to getting started

– Babylog VN500, Infinity C500, PS500 and
GS500 are reprocessed and assembled ready
for operation.
– The electrical power supply and the gas supply
must be connected.
– The toggle switches Babylog VN500 and
PS500 are set to (on).
Start
Babylog VN500 provides you with two options:
– Use settings of previous patient (B)
– Admit new patient (C)
If the Start dialog is closed via the X (D) button,
Babylog VN500 adopts the settings of the previous
patient.
Instructions for Use Infinity Acute Care System – Babylog VN500 SW 2.n
B C
D