Dräger Babylog VN500 Instructions For Use Manual page 60

Getting Started
Prerequisite: The Start dialog is opened.
Start
A
1 Touch the following button for a new patient:
– New Ped. pat. (A) for new pediatric patients
– New Neo. (B) for new neonatal patients
The respective button turns yellow.
2 Confirm with the rotary knob.
The Start/Standby page is displayed.
Babylog VN500 is in standby mode.
Ventilation parameter start-up settings by
patient category
The Start/Standby page (C) contains the buttons
for the patient category:
New Ped. pat. (D)
New Neo. (E)
Start/Standby
C
D
E
F
1 Touch the button for the desired patient
category (D) or (E).
2 Confirm with the rotary knob.
60
B
Instructions for Use Infinity Acute Care System – Babylog VN500 SW 2.n
The ventilation parameters displayed in the lower
part of the page (F) are the start-up settings for the
selected patient category.
Determining the start-up settings can take up to
5 seconds. No entries can be made during this
time.
Ventilation parameter start-up settings by
body height/body weight
Prerequisite: In the System setup dialog window,
the Weight function was configured and a new pa-
tient was admitted.
In the Ped. pat. patient category, the
Start/Standby page (C) contains the button for
body height (G) and the field for the ideal body
weight (H).
Start/Standby
C
G
1 Touch the button for the body height (G).
2 Set the body height by turning the rotary knob
and push to confirm.
Babylog VN500 determines the start-up values for
VT, RR, Slope and Flow trigger based on the ideal
body weight calculated from the body height. The
values for VT and RR are displayed in the lower
part of the page (F). The other ventilation parame-
ters displayed in the lower part of the page are start-
up settings for the selected patient category.
In the Neo. patient category, the patient's body
weight is set directly. The Start/Standby page (C)
contains the button for this start-up body weight (I).
H
F