Setting Ventilation Parameters - Dräger Babylog VN500 Instructions For Use Manual

For information on changing the assignment of ven-
tilation modes, see "Configuring start-up settings
for the ventilation modes" on page 152.
Selecting an additional ventilation mode in the
dialog window
1 Touch the Other modes (D) tab.
Ventilation settings
E
All the available ventilation modes (E) are dis-
played.
2 Touch the button for the corresponding ventila-
tion mode. The color of the (D) tab turns yellow.
3 Confirm with the rotary knob.
The additional ventilation mode is displayed in the
fifth tab (C). The ventilation mode is active.
Changing the ventilation mode
Ventilation settings
F
1 Touch the corresponding tab, e.g., (F). The col-
or of the tab turns yellow.
2 Preset the ventilation parameters if necessary.
3 Confirm with the rotary knob. The color of the
tab turns dark green.
The ventilation mode is active. The settings are ap-
plied to the patient.
Instructions for Use Infinity Acute Care System – Babylog VN500 SW 2.n
C
D

Setting ventilation parameters

Prerequisite: The Basic settings (A) page is
opened.
Ventilation settings
C
1 Touch the corresponding therapy control, e.g.,
(B).
2 Set the value by turning the rotary knob and
push to confirm.
The additional ventilation parameters derived from
the ventilation parameter are calculated by
Babylog VN500 and displayed in the setting assis-
tance field (C).
Information is displayed in the message field (D),
e.g., when the setting limit of a parameter has been
reached.
Setting ventilation parameters in the therapy
bar
The ventilation parameters of the active ventilation
mode can also be set with the therapy controls in
the therapy bar (E).
Additional information
"Exceeding the set limit of a ventilation parameter"
on page 35.
"Direct setting of ventilation parameters (Quick-
Set)" on page 35.
Operation
D
A
B
E
75