Error Log Clear: 21 023 - Omron SYSMAC CS1W-SCB41-V1 Operation Manual

Error Logs
Comments

11-4-9 ERROR LOG CLEAR: 21 023

Command Format
Response Format
Comments
ing from the beginning record number. The total number of bytes for the error
log data required is calculated as follows:
No. of records x 10 bytes
The configuration of each error log record is returned in 10 bytes, as follows:
1st byte
01
07
Error code
Error Code and Details
Indicates the error contents of the error recorded. Refer to 11-4-4 Error Codes
and Details.
Minute, Second, Day, Hour, Year, Month
Records the time the error occurred.
If the error log does not contain the specified number of records, the records
up to the last recorded stored at the time the command was executed will be
returned, and a normal response will be returned. The number of records
actually read will be returned as the number of stored records.
If the beginning record is specified higher than the current number of records
in the error log, an end code of 1103 Hex will be returned.
If the beginning record number is specified as 0000, the response will be com-
pleted normally, even if no error log is recorded.
If the number of records is set to 0000, the end code will be returned as 110C
Hex.
This command clears all stored error log records to 0.
The ERROR LOG CLEAR: 21 03 command clears the error log records that
are stored in the RAM error log table and the EEPROM error log table.
Details
Minute Day Hour Year Month
Second
21 03
Command
code
21 03
Command End code
code
Section 11-4
10th byte
353