Omron SYSMAC CS1W-SCB41-V1 Operation Manual page 252

Protocol Conversion
Select the Unit.
Select the port.
Select this option.
Note
Network-to-Serial
FINS message
User-specified
FINS command
Serial Communications Unit/Board
CPU Unit
Protocol
conversion
Host Link header
Used as Host
Link Master
CS/CJ-series or CVM1/CV-series PLC (Host Link Slave)
Enter the unit number for the
actual Host Link (values are
incremented by 1 automatically).
When using the CX-Programmer, enter the actual Host Link unit number. Do
not add 1 to the value. The CX-Programmer will automatically add 1 internally.
Access from CX-Programmer Connected to Network
CX-Programmer, etc.
Network (Ethernet, Controller
LInk, DeviceNet)
User-specified RS-422A/485
Terminator
FINS command
(Host Link)
The Serial
Communications port
address is automatically
calculated.
Details
Personal computers (e.g., CX-Pro-
grammer) connected through the
network to the PLC master can
access a PLC slave that is con-
nected serially to the PLC master
via Host Link.
Section 6-5
Routing tables to
treat serial
communications
path as network
Required
223