Omron SYSMAC CS1W-SCB41-V1 Operation Manual page 207

Using Protocol Macros
Flags
Operand Areas and Address Ranges
Area
CIO Area
Work Area
Holding Area
Auxiliary Area
Timer Area
Counter Area
Data Memory (DM) Area
Extended Data Memory (EM) Area
Extended Data Memory (EM) Area
(including bank specification)
Indirect DM/EM address, Binary
Indirect DM/EM address, BCD
Constant Area
Data Registers
Index Registers, direct
Index Registers, indirect
178
Name
Error Flag
Access Error Flag AER
C1
CIO 0000 to CIO 6143
W000 to W511
H000 to H511
A000 to A959
T0000 to T4095
C0000 to C4095
D00000 to D32767
E00000 to E32767
En_00000 to En_32767 (n = 0 to C)
@D00000 to @32767, @E00000 to @E32767,
@En_00000 to @En_32767
*D00000 to *D32767, *E00000 to *E32767,
*En_00000 to *En_32767
See Control Data 1
(C1).
DR0 to DR15
---
,IR0 to ,IR15
-2048 to +2047,IR0 to -2048 to +2047,IR15
DR0 to DR15,IR0 to IR15
,IR0+(++) to ,IR15+(++)
,-(- -)IR0 to ,-(- -)IR15
Note The EM Area cannot be specified for the receive data when the interrupt noti-
fication function is being used for a Serial Communications Board. If the EM
Area is specified, a protocol macro syntax error will occur and A42410 will
turn ON.
Label ON
• The Communications Port Enabled
ER
Flag for the specified communica-
tions port (internal logical port) was
OFF when the instruction was exe-
cuted.
• The specified serial port (physical
port) is not set to protocol macro
mode.
• The data setting in C1 is not within
the allowed range.
• The number of words specified in S
or D exceeds 249 (when a word
address was specified for S or D).
A read/write-protected area was
specified for send data or receive
data.
A write-protected area was specified
for receive data.
C2
0000 to 037E Hex #0000 to FFFF
(0 to 999) (Binary data)
---
Section 5-4
OFF
All other cases
All other cases
S R
A448 to A959
---
---
(see note)
(see note)
(see note)
(see note)
(see note)