Omron SYSMAC CS1W-SCB41-V1 Operation Manual page 79

Basic Operating Procedure
Board
(CS Series only)
1900 n
Board
(CS Series only)
Port 1 Port 2
1909 1919
Board
(CS Series only)
Port 1 Port 2
D32000 D32010
D32001 D32011
D32002 D32012
D32003 D32013
D32004 D32014
D32005 D32015
50
2. Set the allocated Software Switches.
Unit
(CS/CJ Series)
12
04
The enable/disable status for the Serial Gateway is automatically indicated
by the following flag.
Unit
(CS/CJ Series)
Port 1 Port 2
n+9 n+19 08
3. Set the local network table in the routing tables as required (using CX-Net).
No-protocol Mode
The following example is for the default (standard) communications condi-
tions, with the send delay set to 100 ms, start code included (e.g., @), end
code included (CR + LF), and number of receive bytes set to 100 bytes.
Unit
(CS/CJ Series)
Port 1 Port 2
m m+10 15
11 to 08
m+1 m+11 03 to 00
m+2 m+12 15
11 to 00
m+3 m+13 15
m+4 m+14 15 to 08
m+5 m+15 12
09 to 08
07 to 00
Bit
Port 2 Serial Gateway Prohibit Switch (protocol mac-
ros)
0: Serial Gateway not prohibited
1: Serial Gateway prohibited
Port 1 Serial Gateway Prohibit Switch (protocol mac-
ros)
0: Serial Gateway not prohibited
1: Serial Gateway prohibited
Bit
Serial Gateway Prohibited Flag
1: Serial Gateway prohibited
1: Serial Gateway not prohibited
Bit Setting
0 Start bits: 1 bit
Data length: 7 bits
Parity: Even
Stop bits: 2 bits
Baud rate: 9,600 bps
3 hex No-protocol
0 hex The baud rate is 9,600 bps when the default
settings are used.
1 Send delay: User-specified
00 hex Send delay setting range: 10 decimal (000A
hex), Unit: 10 ms
1 CTS control 1: Yes
40 hex Start code: @ (40 hex)
1 Start code: Yes
10 End code: CR + LF
64 hex Number of receive data bytes: 100 bytes
Section 1-9
n = 1500 + 25 × unit number
Function
Meaning
Meaning