Changing The User Interface Language; Entering Asian Characters - Siemens SINUMERIK 828D Operating Manual
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Introduction
1.4 User interface
1.4.11
Changing the user interface language
Procedure
Note
Changing the language directly on the input screens
You can switch between the user interface languages available on the controller directly on
the user interface by pressing the key combination <CTRL + L>.
1.4.12
Entering Asian characters
You have the possibility of entering Asian characters.
Note
Call the input editor with <Alt + S>
The input editor can only be called there where it is permissible to enter Asian characters!
You can select a character by using the Pinyin phonetic notation, which enables Chinese
characters to be expressed by combining Latin letters.
The editor is available for the following Asian languages:
40
1.
Select the "Startup" operating area.
2.
Press the "Change language" softkey.
The "Language selection" window opens. The language set last is
selected.
3.
Position the cursor on the desired language.
4.
Press the "OK" softkey.
- OR -
Press the <INPUT> key.
The user interface changes to the selected language.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling
Advertisement
Table of Contents
