Introduction
2.4 Operator interface
2.4.11
Changing the user interface language
Procedure
Note
Changing the language directly on the input screens
You can switch between the user interface languages available on the controller directly on
the user interface by pressing the key combination <CTRL + L>.
48
1.
Select the "Start-up" operating area.
2.
Press the "Change language" softkey.
The "Language selection" window opens. The language set last is se-
lected.
3.
Position the cursor on the desired language.
4.
Press the "OK" softkey.
- OR -
Press the <INPUT> key.
The user interface changes to the selected language.
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Universal