Showing And Hiding The Tool Path; Program Control During The Simulation; Changing The Feedrate - Siemens SINUMERIK 828D Operating Manual

Simulating machining

5.7 Program control during the simulation

5.6.2

Showing and hiding the tool path

The path display follows the programmed tool path of the selected program. The tool paths
can be shown or hidden as required.
Procedure
5.7 Program control during the simulation
5.7.1

Changing the feedrate

You can change the feedrate at any time during the simulation.
You can track the changes in the dialog line.
Note
If you are working with the "Simultaneous recording" function, the override rotary switch on
the control panel is used.
Procedure
162
1. The simulation or the simultaneous recording is started.
2. Press the "<<" softkey to switch to the main screen, if required.
2. Press the ">>" softkey.
The tool path or tool paths for several tools are displayed in the active
view. The path is continuously updated as a function of the tool
movement.
3. Press the softkey to hide the tool paths.
The tool paths are still generated in the background and can be
shown again by pressing the softkey again.
4. Press the "'Delete tool path" softkey.
All tool paths so far generated, including tool paths generated in the
background are deleted.
1. Simulation is started.
2. Press the "Program control" softkey.
3. Press the "Override +" or "Override -" softkey to increase or decrease
the feedrate by 5%.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling