Skip Blocks - Siemens SINUMERIK 828D Operating Manual
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Machining the workpiece
4.8 Intervening in the program sequence
Display / response of active program controls:
If a program control is activated, the abbreviation of the corresponding function appears in
the status display as response.
Proceed as follows
See also
Setting for automatic mode (Page 153)
4.8.2
Skip blocks
It is possible to skip program blocks, which are not to be executed every time the program
runs.
The skip blocks are identified by placing a "/" (forward slash) or "/x (x = number of skip level)
character in front of the block number. Several consecutive blocks can also be skipped.
The statements in the skipped blocks are not executed, i.e. the program continues with the
next block, which is not skipped.
The number of skip levels that can be used depends on a machine datum.
138
1.
Select the "Machine" operating area.
2.
Press the <AUTO> or <MDA> key.
3.
Press the "Prog. cntrl." softkey.
The "Program control" window appears.
Machine manufacturer
Please also refer to the machine manufacturer's instructions.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling
Advertisement
Table of Contents
