Residual Material Contour Spigot (Cycle63) - Siemens SINUMERIK 828D Operating Manual

Programming technological functions (cycles)
8.3 Contour milling
Parameter Description
Lift mode Lift mode before new infeed
If the machining operation requires several points of insertion, the retraction height can
be programmed:
to RP
•
Z0 + safety clearance
•
When making the transition to the next insertion point, the tool returns to this height. If
there are no elements larger than Z0 (X0) in the pocket area, then Z0 (X0) + safety
clearance can be programmed as the lift mode.
FS Chamfer width for chamfering - (only for chamfering machining)
ZFS Insertion depth of tool tip (abs or inc) - (for machining only)
8.3.13

Residual material contour spigot (CYCLE63)

Function
When you have milled a contour spigot and residual material remains, then this is
automatically detected. You can use a suitable tool to remove this residual material without
having to machine the whole spigot again, i.e. avoiding unnecessary non-productive motion.
Material that remains as part of the finishing allowance is not residual material.
The residual material is calculated on the basis of the milling cutter used for clearing.
If you mill several spigots and want to avoid unnecessary tool changes, clear all the spigots
first and then remove the residual material. In this case, for removing the residual material,
you also have to enter a value for the reference tool TR parameter, which, for the ShopTurn
program, additionally appears when you press the "All parameters" softkey. When
programming, you must then proceed as follows:
1. Contour blank 1
2. Contour spigot 1
3. Clear spigot 1
4. Contour blank 2
5. Contour spigot 2
6. Clear spigot 2
7. Contour blank 1
8. Contour spigot 1
9. Clear residual material spigot 1
10. Contour blank 2
11. Contour spigot 2
12. Clear residual material spigot 2
300
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Unit
mm
mm
mm
mm
mm
HMI sl Milling