Siemens SINUMERIK 828D Operating Manual page 115

Parameter Description
TC Name of swivel data set
0: Remove the swivel head, deselect the swivel data set
No entry: No change to the set swivel data set
Retract •
•
•
•
•
Swivel plane •
•
Swivel mode •
•
Z Angle of rotation in the plane (direct swivel)
Axis sequence Sequence of the axes which are rotated around:
XYZ, XZY, YXZ, YZX, ZXY, ZYX
X Rotation around X
Y Rotation around Y
Z Rotation around Z
A Axis angle (swivel directly)
B Axis angle (swivel directly)
Direction Preferred direction of rotation for 2 alternatives (swiveling axis-by-axis)
+: Larger angle of the axis on the scale of the swivel head / swivel table
-: Smaller angle of the axis on the scale of the swivel head / swivel table
Tool Correction: The position of the tool tip is maintained during swiveling
No correction: The position of the tool tip changes during swiveling
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Press the "Set zero plane" softkey to set the actual swivel plane to the
new zero plane.
Press the "Delete zero plane" softkey to delete the actual swivel
plane.
No: No retraction before swiveling
Fixed point 1: Retraction in the direction of machine axis Z to the fixed point of
machine axis Z defined by the machine manufacturer Z.
Fixed point 2: Retraction in the direction of machine axis Z and then in X,Y to the
fixed points defined by the machine manufacturer
Retraction, maximum in the tool direction up to the software end position
Retraction, incremental in the tool direction up to a maximum of the software end
position. The retraction path is entered into parameter ZR.
New: New swivel plane
Additive: Additive swivel plane
Axis by axis: Rotate coordinate system axis-by-axis
Direct: Directly position rotary axes
Positions the rotary axes of the active swivel data set
Angle of rotation in the plane around the tool axes
Execution in manual mode
3.5 Swiveling
Unit
Degrees
Degrees
Degrees
Degrees
Degrees
Degrees
115