Siemens SINUMERIK 828D Operating Manual page 417

Error messages
Error message
Error occurred when closing a connection
Error occurred when establishing a connection.
Error occurred while establishing a connection:
Incorrect entry or no authorization.
Incorrect data
Function not available
Unknown error - error code:%1
Procedure
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1. Select the "Startup" operating area.
2. Press the "HMI" and "Log. drive" softkeys.
The "Set Up Drives" window opens.
3. Select the data for the corresponding drive or enter the necessary
data.
4. Press the "Activate drive" softkey.
The drive is activated.
The operating system now checks the entered data and whether the
connection is established. An OK message is output in the dialog line if
an error is not identified.
The drive can be accessed.
- OR -
If the operating system identifies an error, then you receive an error
message.
Press the "OK" softkey.
You then return to the "Configure drives" window. Check and correct
your entries and re-activate the drive.
If you press the "OK" softkey, the modified data are accepted without
any feedback message. You do not receive any message about a
successful or unsuccessful connection.
If you press the "Cancel" softkey, then all of the data that has not been
activated is rejected.
Meaning
An existing drive was not able to be deactivated.
Drive connection was not able to be established.
Drive connection was not able to be established.
The entered data are either incorrect or
inconsistent.
The function is not supported with the current
software release.
Error was not able to be assigned.
Setting up drives
13.2 Setting up drives
417