Changing The User Interface Language - Siemens SINUMERIK 840D sl Operating Manual

Introduction
1.4 User interface
Channel switchover
1.4.11

Changing the user interface language

Procedure
Note
Changing the language directly on the input screens
You can switch between the user interface languages available on the controller directly on
the user interface by pressing the key combination <CTRL + L>.
36
You can switch over to the next channel by touching the channel
display in the status display.
1. Select the "Startup" operating area.
2. Press the "Change language" softkey.
The "Language selection" window opens. The language set last is
selected.
3. Position the cursor on the desired language.
4. Press the "OK" softkey.
- OR -
Press the <INPUT> key.
The user interface changes to the selected language.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning