Siemens SINUMERIK 828D Operating Manual page 373

Tool parameters
Column heading
Location
BS
* If activated in magazine
selection
Type
Tool name
ST
D
Δ Length
Δ Radius
T C
Setpoint
Prewarning limit
Tool life
Workpiece count
Wear *
*Parameter depends on
selection in TC
G
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Meaning
Magazine/location number
The magazine location numbers.
•
The magazine number is specified first, followed by the location
number in the magazine.
If there is only one magazine, only the location number is displayed.
Load position in the load magazine
•
The following additional icons can also be displayed for other magazine
types (e.g. for a chain):
Spindle location as an icon.
•
Locations for gripper 1 and gripper 2 (applies only when a spindle
•
with dual gripper is used) as icons.
Tool type
Depending on the tool type (represented by an icon), certain tool offset
data is enabled.
The tool is identified by the name and the replacement tool number. You
can enter the name as text or number.
Replacement tool number (for replacement tool strategy).
Cutting edge number
Length wear
Radius wear
Selection of tool monitoring
- by tool life (T)
- by count (C)
- by wear (W)
The wear monitoring is configured via a machine data item.
Please refer to the machine manufacturer's instructions.
Setpoint for tool life, workpiece count, or wear.
Specification of the tool life, workpiece count or wear at which a warning
is displayed.
Tool life
Number of workpieces
Tool wear
The tool is disabled when the checkbox is selected.
Tool management
11.6 Tool wear
373