Siemens SINUMERIK 828D Operating Manual page 328

Programming technological functions (cycles)
8.5 Further cycles and functions ShopMill
Procedure
Parameter
L
α
F
Radius compensation
328
1. The ShopMill program to be edited has been created and you are in
the editor.
2. Press the menu forward key and the "Straight Circle" softkey.
3. Press the "Polar" and "Straight polar" softkeys.
4. Press the "Rapid traverse" softkey to enter the feedrate in rapid
traverse.
Description
Distance to the pole, end point
Polar angle to the pole, end point (abs) or
change in polar angle to the pole, end point (inc)
Machining feedrate
Input defining which side of the contour the cutter travels in the programmed
direction:
Radius compensation to left of contour
Radius compensation to right of contour
Radius compensation off
The set radius compensation remains as previously set
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
Unit
mm
Degrees
mm/rev
mm/min
mm/tooth
HMI sl Milling