Simulation Before Machining Of The Workpiece - Siemens SINUMERIK 828D Operating Manual

5.2

Simulation before machining of the workpiece

Before machining the workpiece on the machine, you have the option of performing a quick
run-through in order to graphically display how the program will be executed. This provides a
simple way of checking the result of the programming.
Feedrate override
Feedrate override is also active during simulation.
You can change the feedrate during the simulation via the user interface.
0 %: The simulation stops.
≥ 100 %: The program is executed as quickly as possible.
Procedure
Table 5- 1
Note
Operating area switchover
The simulation is exited if you switch into another operating area. If you restart the
simulation, then this starts again at the beginning of the program.
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1. Select the "Program Manager" operating area.
2. Select the storage location and position the cursor on the program to
be simulated.
3. Press the <INPUT> or <Cursor right> key.
- OR -
Double-click the program.
The selected program is opened in the "Program" operating area.
4. Press the "Simulation" softkey.
The program execution is displayed graphically on the screen. The
machine axes do not move.
5. Press the "Stop" softkey if you wish to stop the simulation.
- OR -
Press the "Reset" softkey to cancel the simulation.
6. Press the "Start" softkey to restart or continue the simulation.
5.2 Simulation before machining of the workpiece
Simulating machining
157