Siemens SINUMERIK 828D Operating Manual page 466

Ladder add-on tool
19.19 Displaying cross references
Opening program blocks in the ladder diagram
From the cross references, you have the option of going directly to the location in the
program where the operand is used. The corresponding block is opened in window 1 or 2
and the cursor is set to the corresponding element.
Searching
Using a specific search, you can go directly to the location that you wish to view in more
detail:
● Search for operand
● Jump to sought line
Procedure
466
1. Ladder add-on tool is opened.
2. Press the "Cross refs." softkey.
The list of cross references appears and the operands are displayed
sorted according to absolute address.
3. Press the "Symbol. address" softkey.
The list of operands is displayed sorted according to symbolic
address.
4. Press the "Absolute address" softkey to return to the display showing
the absolute addresses.
5. Select the desired cross reference and press the "Open in window 1"
or "Open in window 2" softkey.
The ladder diagram is opened, and the selected operand is marked.
6. Press the "Find" softkey.
The "Find / Go To" window appears.
7. Select "Find operand" or "Go to" and enter the sought element or the
desired line and select the search order (e.g. search up).
8. Press the "OK" softkey to start the search.
9. If an an element is found that corresponds to the sought element, but
is not at the appropriate position, press the "Continue search" softkey
to find where the search term occurs next.
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling