Siemens SINUMERIK 828D Operating Manual page 67
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
- OR -
An electronic workpiece probe is inserted in the spindle and activated when measuring the
workpiece zero automatically.
Procedure
...
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1.
Select the "Machine" operating area and press the <JOG> key.
2.
Press the "Workpiece zero" and "Set edge" softkeys.
The "Set edge" window opens.
3.
Select "Measuring only" if you only want to display the measured
values.
- OR -
Select the desired work offset in which you want to store the zero point
(e.g. basis reference).
- OR -
Press the "Select WO" softkey and select the work offset in which the
zero point is to be saved in the "Work Offset – G54 ... G599" window
and press the "In manual" softkey.
You return to the measurement window.
4.
Use the softkeys to select in which axis direction you want to approach
the workpiece first.
5.
Select the measuring direction (+ or -) you want to approach the
workpiece in.
The measuring direction cannot be selected for Z0.
6.
In X0, Y0, or Z0, specify the setpoint position of the workpiece edge
you are approaching.
The setpoint position corresponds, e.g. to the dimension specifications
of the workpiece edge from the workpiece drawing.
7.
Traverse the tool up to the workpiece edge and press the "Set WO"
softkey to measure the workpiece zero manually.
Setting up the machine
2.6 Measuring the workpiece zero
67
Advertisement
Table of Contents
