Teach In Rapid Traverse G0 - Siemens SINUMERIK 828D Operating Manual
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Proceed as follows
10.4.2
Teach in rapid traverse G0
You traverse the axes and teach-in a rapid traverse block with the approached positions.
Note
Selection of axes and parameters for teach-in
You can select the axes to be included in the teach-in block in the "Settings" window.
You also specify here whether motion and transition parameters are offered for teach-in.
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1
Select the "Machine" operating area.
2.
Press the <AUTO> or <MDA> key.
3.
Press the <TEACH IN> key.
4.
Press the "Teach prog." softkey.
5.
Use the cursor and input keys to position the cursor at the desired
point in the program.
If an empty row is not available, insert one.
6.
Press the softkeys "Rap. tra. G0", "Straight line G1", or Circ. interm.
pos. CIP" and "Circ. end pos. CIP".
The relevant windows with the input fields are displayed.
7.
Traverse the axes to the relevant position.
8.
Press the "Accept" soft key.
A new program block will be inserted at the cursor position.
- OR -
Press the "Cancel" softkey to cancel your input.
Teaching in a program
10.4 Teach-in via window
345
Advertisement
Table of Contents
