Touch Operation; Changing The User Interface Language - Siemens SINUMERIK 840D Operating Manual

Introduction
1.4 User interface
1.4.10

Touch operation

If you have an operator panel with a touch screen, you can perform the following functions
with touch operation:
Operating area switchover
Channel switchover
1.4.11

Changing the user interface language

Procedure
42
You can display the operating area menu by touching the display symbol for
the active operating area in the status display.
You can switch over to the next channel by touching the channel
display in the status display.
1. Select the "Startup" operating area.
2. Press the "Change language" softkey.
The "Language selection" window opens. The language set last is
selected.
3. Position the cursor on the desired language.
4. Press the "OK" softkey.
- OR -
Press the <INPUT> key.
The user interface changes to the selected language.
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Milling