Setting For Automatic Mode - Siemens SINUMERIK 828D Operating Manual

Procedure
4.13

Setting for automatic mode

Before machining a workpiece you can test the program without moving the machine axes.
This allows you to detect programming errors early on. Use the dry run feedrate for this
purpose.
In addition, you have the option of additionally limiting the traversing speed for rapid traverse
so that when running-in a new program with rapid traverse, no undesirable high traversing
speeds occur.
Dry run feedrate
The feedrate defined here replaces the programmed feedrate during execution if you have
selected "DRY dry run feedrate" under program control.
Reduced rapid traverse
This value entered here reduces the rapid traverse to the entered percentage value if you
selected "RG0 reduced rapid traverse" under program control.
Displaying measurement results
Using an MMC command, you can display measurement results in a part program:
You set
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1. Select the "Machine" operating area.
2. Press the <AUTO> key.
3. Press the "Times, Counter" softkey.
The "Times, Counter" window opens.
4. Select "Yes" under "Count workpieces" if you want to count completed
workpieces.
5. Enter the number of workpieces needed in the "Desired workpieces"
field.
The number of workpieces already finished is displayed in "Actual
workpieces". This value can be corrected if necessary.
After the defined number of workpieces is reached, the current
workpieces display is automatically reset to zero.
Machining the workpiece
4.13 Setting for automatic mode
153