Siemens SINUMERIK 828D Operating Manual page 205

Procedure
Table 7- 2
Parameter Description
Blank The following blanks can be selected:
•
•
•
•
•
X0 1. Corner point X - (only for cuboid)
Y0 1. Corner point Y - (only for cuboid)
X1 2. Corner point X (abs) or 2nd corner point X referred to X0 (inc) - (only for cuboid)
Y1 2. Corner point Y (abs) or 2nd corner point Y referred to Y0 (inc) - (only for cuboid)
ZA Initial dimension
ZI Final dimension (abs) or final dimension in relation to ZA (inc)
PL Machining plane
G17 (XY)
G18 (ZX)
G19 (YZ)
RP Retraction plane (abs)
SC Safety clearance (inc)
Acts in relation to the reference point. The direction in which the safety clearance is
effective is automatically determined by the cycle.
Machining Milling direction:
direction
•
•
Retraction position Lift mode before new infeed
pattern
•
•
HMI sl Milling
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
1. Select the "Program" operating area.
2. Press the "Various" and "Settings" softkeys.
The "Settings" input window opens.
Cuboid
Tube
Cylinder
Polygon
Centered cuboid
Climbing
Conventional
to RP
optimized
Creating a ShopMill program
7.13 Changing program settings
Unit
mm
mm
mm
205