Siemens SINUMERIK 828D Operating Manual page 82
Hmi sl milling
Hide thumbs
Also See for SINUMERIK 828D:
- Function manual (1799 pages) ,
- Commissioning manual (1167 pages) ,
- Operating manual (926 pages)
Table of Contents
Advertisement
Setting up the machine
2.6 Measuring the workpiece zero
Rectangular
spigot
1 circular
spigot
2 circular
spigots
3 circular
spigots
82
If these softkeys are not listed, press any vertical softkey (with the
exception of "Set edge") and in the drop-down list, select the desired
measurement version.
3.
Traverse the workpiece probe to approximately the center above the
rectangular or circular spigot, or for several, above the first spigot to
be measured.
4.
Specify whether you want "Measurement only" or in which work offset
you want to store the zero point.
• Enter the infeed value in "DY" to determine the measuring depth.
5.
• In field "L" enter the length (1st axis of the working plane) and in
"W" (2nd axis of the working plane) enter the width of the spigot, if
the measuring stroke would not reach the edges.
- OR -
• Enter the approximate diameter of the spigot into "Øspigot".
• Enter an angle in "Probe angle".
This is how you limit the area in which rapid traverse can be used. If
no diameter is entered, traversing starts from the starting point at
measurement feedrate.
With the probe angle you can turn the traversing direction of the probe
through any angle.
- OR -
• Enter the approximate diameter of the spigot into "Øspigot".
• Enter the infeed value in "DY" to determine the measuring depth.
• In "Angle offs.", select entry "Coor. rotation" or "Rotary axis A, B,
C".
• Enter the setpoint angle.
• Enter the position setpoints (Z0/X0) for the center point of the first
spigot.
The setpoint angle refers to the 1st axis of the working plane (X/Y
plane).
The input fields for the setpoint positions are only active if you
selected the angle offset via coordinate rotation.
- OR -
• Enter the approximate diameter of the spigot into "Øspigot".
• Enter the infeed value in "DY" to determine the measuring depth.
• In "Angle offs.", select entry "No", or in "Angle offs." select entry
"Yes" if you want to align using coordinate rotation.
• Specify the setpoint angle if you selected entry "Yes" for "Angle
offs."
• Enter the setpoint positions Z0 and X0 to determine the center
point of the circuit on which the center points of three spigots lie.
The setpoint angle refers to the 1st axis of the working plane (X/Y
plane). This input field only appears if you specified "Yes" for "Angle
offs."
- OR -
Operating Manual, 06/2009, 6FC5398-7CP20-0BA0
HMI sl Milling
Advertisement
Table of Contents
